Eschenbach Optik Eclipse - Manual (Page 12)

Page 12
Rev E US EN
Focus button is pressed or when the zoom level is altered. If the height
of the material under the camera is changed, it will be necessary to
press the focus button again.
Manual Focus: This mode is useful if you require an image that is
slightly out of focus or you are looking at an awkward object that
the camera will not focus on correctly. In this mode you must press
+
(Hold focus button down and press Zoom Up or Down) to
set your desired focus.
6C. Factory Defaults
Selecting this menu item will restore all video settings, modes,
colours and button functions to their factory settings. This option is
provided in case you set the unit into a mode that you cannot remember
how to undo. You will be prompted to press the middle function button
on the front panel to reset the unit;
pressing any other button will exit
without altering the current settings.
The internal firmware revision is displayed on the top line. Generally, it
is of no concern.
If, for some reason, you cannot see the menu to choose Factory
Defaults then perform the following sequence of button presses:
• Power the unit off then on again. Wait for a few seconds to allow the
start-up sequence to complete.
• Press and hold the mode button
until the beep is heard.
• Press Zoom-Up once.
• Press Focus once.
• Press the middle function button and the factory defaults should be
restored.
Rev 1.01
PRESS X TO RESET