Environmental Express SimpleDist - Manual (Page 10)

800.745.8218 / 843.576.1147 / www.environmentalexpress.com Environmental Express • 8
SimpleDist: Operation and Instruction Manual About Your HotBlock TM
HotBlock TM Unpacking and Installation
Unpacking Your HotBlock TM :
1. Remove the HotBlock TM from the shipping container by lifting from the bottom of the block. The lid should not be
used for lifting.
2. Your HotBlock TM is shipped with metal screws securing the bottom panel. The metal screws must be removed before
operating your HotBlock TM . Remove the metal screws and replace them with the PVC screws and rubber feet included
with your shipment. The corrosion-resistant PVC screws and rubber feet are designed to secure the bottom plate.
Important: Do not over tighten the PVC screws!
Installation Requirements
Locate the HotBlock TM under a fume hood with a minimum face velocity of 100fpm, and allow a minimum of 2" of space on
all sides. The following environmental conditions should be observed:
• Ambient temperature range: 5-30°C
• Ambient relative humidity: 0-90%RH
• Altitude: sea level to 2500 meters
HotBlocks TM are rated as Pollution Degree 2 and Installation Category 2.
Electrical Requirements
Required Voltage: 120 volts, ~60Hz, 15A
(all HotBlocks TM are also available in 240V
with CE mark)
Power should not vary greater than±10%. Use the supplied heat-resistant power cord or equivalent to connect to the power
supply.
For safety reasons, a separate power receptacle should be provided for each unit in the system. Do not use extension cords or
outlet adaptors. Make certain that power outlets are earth-grounded at the grounding pin.
See individual specifications for each HotBlock
TM model.