beautypg.com

Enerpac XLP 25 ton User Manual

Instruction sheet, Xlp-series 25 ton workshop presses

background image

1

2.0 SAFETY ISSUES

Read all instructions, warnings and cautions carefully. Follow all

safety precautions to avoid personal injury or property damage

during system operation. Enerpac cannot be responsible for

damage or injury resulting from unsafe product use, lack of

maintenance or incorrect product and/or system operation.

Contact Enerpac when in doubt as to the safety precautions

and operations. If you have never been trained on high-pressure

hydraulic safety, consult your distribution or service center for a

free Enerpac Hydraulic safety course. Failure to comply with the

following cautions and warnings could cause equipment damage

and personal injury.

A CAUTION is used to indicate correct operating or

maintenance procedures and practices to prevent

damage to, or destruction of equipment or other

property.

A WARNING indicates a potential danger that requires

correct procedures or practices to avoid personal

injury.

A DANGER is only used when your action or lack of

action may cause serious injury or even death.

WARNING: Wear proper personal protective gear

when operating hydraulic equipment.

WARNING: Stay clear of loads supported by

hydraulics. A cylinder, when used as a load lifting

device, should never be used as a load holding device.

After the load has been raised or lowered, it must

always be blocked mechanically.

WARNING: USE ONLY RIGID PIECES TO

HOLD LOADS. Carefully select steel or

wood blocks that are capable of supporting

the load. Never use a hydraulic cylinder as

a shim or spacer in any lifting or pressing application.

DANGER: To avoid personal injury keep

hands and feet away from cylinder and

workpiece during operation.

1.0 IMPORTANT RECEIVING INSTRUCTIONS

Visually inspect all components for shipping damage. Shipping

damage is not covered by warranty. If shipping damage is

found, notify carrier at once. The carrier is responsible for

all repair and replacement costs resulting from damage

in shipment.

XLP-Series 25 ton Workshop Presses

Instruction Sheet

EIS 66.111-1

rev. O 02/2011

Repair Parts Sheets for this product are available from the Enerpac web site at www.enerpac.com,

or from your nearest Authorized Enerpac Service Center or Enerpac Sales office.

XLP-Series presses can be set up to perform maintenance and

forming operations. Each press is delivered with cylinder, hose,

couplers and pump. The XLP-Series presses include a lower bed

lifting device. Optional is the V-block workpiece support to facilitate

the positioning of pipes and bars.

GB

Index:

Pages

English (GB) .................................................... 01 - 04

Français (FR) ................................................... 05 - 08

Deutsch (DE) ................................................... 09 - 12

Italiano (IT) ...................................................... 13 - 16

Español (ES) ................................................... 17 - 20

Nederlands (NL) .............................................. 21 - 24

Index:

Pages

Svenska (SE) .................................................. 25 - 28

Norsk (NO) ...................................................... 29 - 32

Suomi (FI) ....................................................... 33 - 36

Polska (PL) ...................................................... 37 - 40

Czech (CZ) ...................................................... 41 - 44

Pycckий (RU) .................................................. 45 - 48

SAFETY FIRST