1 pim configuration, 1 pim commands, Onfiguring – Black Box LR1102A-T1/E1 User Manual
Page 107: Rotocol, Ndependent, Ulticasting, Outing, Pim configuration, Pim commands

20
C
ONFIGURING
P
ROTOCOL
I
NDEPENDENT
M
ULTICASTING
R
OUTING
20.1 PIM Configuration
Protocol Independent Multicast (PIM) protocols route multicast packets to multicast groups. PIM is protocol
independent because it can leverage whichever unicast routing protocol is used to populate unicast routing table. There
are two modes of PIM protocol – Dense mode (DM) and Sparse mode (SM). Black Box supports SM only.
PIM-DM floods multicast traffic throughout the network initially and then generates prune messages as required.
PIM-SM attempts to send multicast data only to networks which have active receivers. This is achieved by having a
common Rendezvous Point (RP) known to the senders and receivers and by forming shared trees from the RP to the
receivers.
PIM-SM is described in RFC 2362.
20.1.1PIM Commands
The general PIM commands supported in this release are:
Global parameters
Enable PIM
Blackbox/configure/ip> pim
Configure PIM mode
Blackbox/configure/ip/pim> mode [sparse | dense]
Configure Assert Holdtime
Blackbox/configure/ip/pim>assert-holdtime
Configure Hello Interval
Blackbox/configure/ip/pim>hello-interval
Configure Hello Holdtime
Blackbox/configure/ip/pim>hello-holdtime
Configure Hello priority
Blackbox/configure/ip/pim>hello-priority
Configure Join/Prune
Holdtime
Blackbox/configure/ip/pim>join-prune-holdtime
Configure Join /Prune
Interval
Blackbox/configure/ip/pim>join-prune-interval
Configure MRT Period
Blackbox/configure/ip/pim>mrt-period