Eberspacher Module Timer - Manual (Page 2)

Preselect heating start
Three switch-on times within the next 24 hours can be selected
or one switch-on time within up to 7 days.
Only 1 switch-on time can be activated at any given time!
1. Select memory and activate:
(proceeding from a neutral setting as long as the display is
visible)
First memory – Press P once
Memory display: 1 (basic setting 12 00)
Second memory – Press
P twice
Memory display: 2 (basic setting 12 00)
Third memory – Press
P three times
Memory display: 3 (basic setting 12 00)
Neutral setting – No memory is activated.
Continue pressing P until the memory display disappears.
2. Start heating within 24 hours
Setting a preselected day:
The preselected day is automatically obtained and does not have
to be set.
Setting a preselected time:
Continue pressing P until the required memory display (1, 2, 3)
flashes on the display.
Briefly press or and release.
The preset time flashes on the display. Use or to set the
preselected time for heating.
Setting is only possible as long as the preselected time flashes
on the display.
Renewed selection: Press
P .
3. Start heating later than 24 hours (max. 7 days)
Setting a preselected time
Continue pressing P until the required memory display (1, 2, 3)
flashes on the display.
Briefly press or and release. The preset time flashes on the
display. Use or to set the preselected time for heating.
Setting a preselected day:
The preselected day starts to flash approximately
5 seconds after the preselected time has been set.
Use or to set the preselected day for heating.
The preselected time and preselected day are stored as soon as
the time display disappears or when the display is changed over
to indicate the time. The memory display indicates the activated
memory. A flashing heating key
( ) additionally indicates an
activated memory.
4. Checking the activated memory
The preselected time of the displayed memory is shown for
approximately 5 seconds. This is then either turned off or the time
is displayed (with ignition “ON”). The display of the preselected
time and preselected data for approx. 5 seconds can be called
by pressing
P once.
Temperature display
With connected outside temperature sensor
(Order No. 25 1482 89 41 00) the temperature can be perma-
nently displayed when the ignition is switched on by pressing
once. When the ignition is switched off, the temperature can be
displayed for 15 seconds by pressing twice.
Please note!
Brief power interruptions will be bridged by the module timer.
All symbols will flash on the display after an extended power
failure. The module clock will have to be totally reset.
The time and weekday are permanently displayed when the igni-
tion is switched on. Their display is switched off after 15 seconds
if the ignition is switched off.
Operation with radio remote control is possible with an additional
facility (receiver module).
If a fault arises while the heating is on and when a diagnosis line
is connected, then the operating display will flash and the
Code No. of the fault will be displayed (consult an authorised
workshop).
On road tankers equipped in conformity with ADR / ADR99, the
module timer is only used to switch the heating on and off. The
time does not have to be set in order to start the heater.
Continuous heating
or heating for a limited period are possible.
As a result of statutory requirements the following functions
cannot be activated:
1. Preselecting heater operation with the module timer.
2. Operation with the radio remote control.
3. Connecting an outside temperature sensor.
12 00
M0
i
12 00
M0
i