Dolan-Jenner MH100 - Manual (Page 3)

DOLAN-JENNER INDUSTRIES, 159 Swanson Rd., Boxborough, MA 01719, U.S.A., 978-263-1400, FAX: 978-266-1618
3
® Fiber-Lite
FUSE REPLACEMENT:
1. Press the ON(1)/OFF(0) switch to the OFF(0) position.
2. Remove the AC line cord from the AC power receptacle.
3. Remove the AC line cord from the power entry module at the rear of the illuminator. The fuse drawer is part of the power
entry module. The drawer is located directly beneath where the AC line cord plugs in.
4. Pull out the fuse drawer. Remove the blown fuse that is positioned closest to the illuminator and discard. The second
fuse is the spare.
5. Place the replacement fuse into the fuse drawer. The fuse will work in either orientation.
6. Push the fuse drawer until it "clicks" into position.
7. Attach the AC line cord to power entry module at the rear of the illuminator. The illuminator is now ready for service.
Replacement Parts
Part No. Description
68600903098 Fuse, 5A, 5 x 20, 250 V, fast blow
686009-03100 Lamp, Metal Halide 100W
Only above parts are replaceable. Return illuminator to factory for warranty service. Attempts to replace other parts voids warranty.
PERFORMANCE STATEMENT
Dolan-Jenner Industries, Inc. (DJI) recognizes that its illuminator products may be used under an almost unlimited
variety of conditions. As such, we are prepared to assist the customer in the selection and application of any of these
products. This includes application engineering, sample testing and other means as determined by DJI.
Where DJI has made specific recommendations for its products, systems, or detection techniques (based on complete
and detailed information furnished by the customer) we will extend every effort to assure that the customer is satisfied with
the performance of our products. Continual development and improvement of DJI products may require changes in details
that do not coincide with descriptions or illustrations shown. All fiber optic bundle diameters are nominal.
Cleaning:
If necessary wipe exterior surfaces only with a soft cloth. Do not use fluids to clean the exterior of the illuminator. Under no
circumstances allow fluids of any kind to enter the illuminator.
WARNING
Replace the fuse with the correctly
rated fuse as listed on the label
on the back of the illuminator. Use of
an improper fuse can create
a hazardous situation.
Fuse Drawer