Despatch S Type - Manual (Page 89)

I-235 (9/03) −
86
−
Step #
Description
door lap. At this time make sure you install and tighten down the remaining fasteners
into oven front and side panels for final connection once the front is plumb.
9.
Final oven front mounting is achieved by securing the oven front mounting angles
located at the base of each door post to the factory floor. Drill 5/8” holes in the
concrete factory floor for 5/8” WEJ-IT anchors supplied with field ship. Insert anchor
with washer and nut, with the nut at the top of the anchor lightly tap anchor into hole
using top of nut so threads are protected. Drive in anchor till nut makes contact with
angle and tighten down nut.
10.
Inside seal installation. Install center vertical lapping door seal and perimeter door
seals with seal holders and fasteners supplied. Refer to door and front assembly
drawing and illustration #8 in the manual for details. Using a 3/8” spacer, gap the
door seal away from the door frame, this will allow the door seal to make better
contact with the door face due to door and frame clearances. Adjust door seals where
the seals come in contact with the door face with a small amount of compression.
Seals should not be over compressed to cause total flattening of the seal ball. Seals
should only form a slight oval for better seal life.
11.
Open and close doors 4-6 times each time checking for proper sealing. Check to
make sure latches are mounted properly. The small door assemblies have only one
latch assembly at the top of the doors. Make sure the latch is adjusted and shimmed
properly so the bottom of door is not forced out. Latch should be adjusted for easy
opening of doors and not overly tightened. Large door assemblies have two latch
assemblies; one at the top and one at the bottom with a floor strike anchored into the
factory floor. Latches should be adjusted for easy opening of doors and not overly
tightened to cause the doors to bow and cause a gap or uneven contact where doors
meet at the center of the doors.
12.
For more information on door and front adjustment refer to “SWING DOOR
TROUBLE SHOOTING INFORMATION” found in the manual.