Danuser EP20 - Manual (Page 9)

Assembly
& Installation
Mini-Excavator Mount
STEP 1: Attach drive unit (1) to the knuckle sub-assembly (2) using pin (3). Secure pin
(3) with lock pin (4).
STEP 2: Remove bucket from dipperstick and curl cylinder pin connections. The
dipperstick pin will be used to attach the knuckle assembly to the dipperstick.
The curl cylinder pin will not be required for drive unit installation.
STEP 3: Space the two ear assemblies (5) to the width of the dipperstick and secure
them to the knuckle sub-assembly (2) using u-bolts (6) and nuts (7). The ear
assemblies should be spaced evenly from the center of the knuckle
sub-assembly and the safety signs should be facing out. Nuts (7) must be
torqued to 75 ft.-lbs. Nuts (7) should be checked and re-torqued after the first
hour of use.
STEP 4: Attach knuckle assembly/drive unit to the dipperstick using the dipperstick pin
removed from the bucket in STEP 2. Secure the bucket pin per vehicle
manufacturer’s recommendations.
= Safety Sign
Location
REF. NO. PART NO. DESCRIPTION QTY.
1 ----- Drive Unit 1
2 10219 Knuckle Sub-Assembly 1
3 10193 Pin (1-1/4” x 9-1/2”) 1
4 20012 Lock Pin 1
5 ----- Ear Assembly 2
6 10220 U-Bolt (1/2” 13 x 3-3/4”) 4
7 6196 Nut (1/2” 13) 8
8 10038 Special Retaining Bolt 1
(3/4” 10 x 4”, Gr. 8, 3/4” of thread)
9 10041 Nut (3/4” 10) 1
Drive unit and auger
exploded views and part lists
are detailed on separate pages
in this manual.
9
Because of the weight of
some components, and
because some
components are difficult
to balance, two people are
required for safe
assembly and installation
of this equipment.
Personal protection
equipment including hard
hat, safety glasses, safety
shoes, and gloves are
recommended during
assembly, installation,
operation, maintenance,
removal, or movement of
the earth auger. Do not
allow long hair, loose
fitting clothing, or jewelry
to be around moving
parts.
5
7
2
6
1
9 8
4
3