Control Company 5133 CONTINUOUS VISUAL ALARM TIMER - Manual (Page 2)

© 2006 Control Company. 92-5133-00 Rev. 0
TRACEABLE
CONTINUOUS
VISUAL ALARM
TIMER
INSTRUCTIONS
Stopwatch (coUnt-Up) tiMinG
1. If the timer is running, press the START/STOP button
and then press the  and  buttons simultaneously.
The display should read 00 00.
2. Press the START/STOP button to begin count-up
timing.
Note: During the first 99 minutes 59 seconds of count-up
time, the resolution is 1 second, after 100 minutes,
the count-up resolution is 1 minute.
3. When timing has been completed and the timing has
been stopped, press the  and  buttons
simultaneously to clear the display to zero.
tiMeoUt
The timer may be stopped during any running time by
pressing the START/STOP button. Timing may be resumed
by pressing the START/STOP button a second time.
aLL opeRationaL DifficULtieS
If this timer does not function properly for any reason,
replace the batteries with new high quality batteries (see
“Battery Replacement” section). Low battery power can
occasionally cause any number of “apparent” operational
difficulties. Replacing the batteries with a new fresh
battery will solve most difficulties.
BatteRy RepLaceMent
An incorrect display, no display or operational difficulties
indicate that the batteries should be replaced. Slide open
the battery cover on the back of the timer. Insert two
new AAA size batteries. Make certain to note the proper
polarity as indicated by the diagram in the battery com-
partment. Do not mix new batteries and old batteries.
Replace the battery cover.
waRRanty, SeRVice, oR caLiBRation
For warranty, service, or calibration contact:
CONTROL COMpANy
4455 Rex Road • Friendswood, Texas 77546 • USA
Ph. 281 482-1714 • Fax 281 482-9448
www.control3.com • [email protected]
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA
®
Traceable ® is a registered trademark of Control Company.