Control Company 1076 ATOMIC WALL CLOCK - Manual (Page 2)

2. Press the SET/WAVE button, the year will flash on
the display.
3. Set the desired year by pressing the “+” or “–”
button. Press and hold the “+” or “–” button to
change the display rapidly.
4. With the desired year on the display, press the SET/
WAVE button. The date will flash.
5. Set the desired date by pressing the “+” or “–”
button. The date will cycle through the day number
first and as the day number passes to the next
month, the month will change. Press and hold the “+”
or “–” button to change the date rapidly.
6. With the desired date on the display, press the SET/
WAVE button. The time-of-day will flash.
7. Set the desired time-of-day by pressing the “+” or
“–” button.
8. With the desired time-of-day on the display, press
the SET/WAVE button. The 12/24 hour time format
and temperature will flash.
9. Set the desired time format by pressing the “+”
button.
10. Set the desired temperature display by pressing the
“–” button.
Control Company Cat. No. 1076
Traceable ® is a registered trademark of Control Company.
© 2013 Control Company. 92-1076-00 Rev. 4 080913
TRACEABLE
DIGITAL RADIO
ATOMIC WALL
CLOCK
INSTRUCTIONS
®
11. With the desired time format and temperature unit on
the display, press the SET/WAVE button to confirm
the entry and exit the setting mode.
NOTE: Any manual changes made will be automatically
overridden with the next completed signal reception from
the Atomic Clock.
RESET BUTTON
Located on back of the unit, this button is only used
when either unit is operating in an unfavorable way
or malfunctioning, most commonly caused by ESD
(electrostatic discharge) or radio interference. To reset
the unit, press the RESET button. All settings will return
to default values. Pressing the RESET button has a
similar effect as removing and re-installing the batteries.
ALL OPERATIONAL DIFFICULTIES
If this clock does not function properly for any reason,
replace the battery with a new high quality battery (see
the “Battery Replacement” section). Low battery power
can occasionally cause any number of “apparent”
operational difficulties. Replacing the battery with a new
fresh battery will solve most difficulties.
BATTERY REPLACEMENT
Erratic readings, a faint display, no display, or a battery
symbol appearing on the display are all indications that
the batteries must be replaced. Remove the battery cover
located on the back of the unit. Remove the exhausted
batteries and replace them with three (3) new AAA alkaline
batteries. Insert the new batteries with the proper polarity
as indicated by the illustration in the battery compartment.
Replace the battery cover.
Replacing the batteries will reset
all settings to default
values.
WARRANTY, SERVICE, OR CALIBRATION
For warranty, service, or calibration contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
www.control3.com • [email protected]
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA