Condux Fiber Optic Cable Puller Hitch Mount - Manual (Page 2)

1. Stabilize truck.
2. Remove pin to separate the jack from puller hitch mount
weldment.
3. Install puller hitch mount weldment to the truck’s hitch (take note,
jack receiver must be on the same side as the capstan).
4. Install and pin jack perpendicular to the puller hitch mount
weldment.
5. Stabilize the jack by cranking on the handle.
NOTE: Do not attempt to jack up the vehicle. This tool is not
intended to be used as a vehicle jack.
NOTE: Must not exceed 800 lbs (3,559 N) of pulling load.
6. Assemble fiber puller frame mount into female mounting tube.
7. Install snap lock pin to secure puller frame mount.
8. Install 30 inch capstan like instructed in its manual.
Removal Procedure
1. Removal is the opposite of the installation procedure.
Installation Procedure
!WARNING: Read and understand all procedure and
safety instructions before using the Condux Fiber
Optic Cable Puller Hitch Mount. Failure to do so
may result in personal injury or property damage.
Save this user’s guide for future reference.
Puller Hitch
Mount Weldment
Pin Hole
Adjustable Jack
!ADVERTENCIA: Favor de leer y comprender todas
las instrucciones de operación y seguridad antes
de usar el Condux Fiber Optic Cable Puller Hitch
Mount. Si Ud. no comprende las instrucciones
favor de consultarle a su jefe.
ADVERTENCIA
Instrucciones de Operación
!CAUTION: Wear personal protective equipment:
hard hat, safety glasses, safety shoes, and leather
work gloves. Failure to do this could result in
personal injury.
Figure 1. Fiber Optic Cable Puller Hitch Mount
2" (51 mm) square
Reese type end
Handle
Pins
2 1 ⁄
2
" (64 mm)
Female Mounting
Tube