Condux Adjustable Manhole Adapter - Manual (Page 2)

1. Place the adapter over the manhole..
2. Unscrew the knobs and adjust the stops until they contact the
manhole’s edge.
3. Retighten the knobs after adjustments.
4. Position the fork over the center tube and secure it with the
thumb screws.
*Comes standard with 4-inch adapter plate
*6” adapter plate available
!WARNING: Read and understand all procedure and
safety instructions before replacing any Condux Swivel
Break Pin. Failure to do so may result in personal injury
or property damage. Save this user’s guide for future
reference.
Manhole adapter comes standard with 4” plate
6” adapter plate is available (P/N 08674752)
Setup Procedure
1. Place adapter over the manhole
2. Loosen knobs and slide movable out until they contact
the manholes edge
3. Tighten knobs
4. Slide plate to center over the pull
5. Position retaining fork over tube and secure thumb
screws
6. Maneuver the cable glider cable puller so the its front
pivoting arm rests in the retaining fork
Note
:
Set up Procedure Parts List
!WARNING: Read and understand all
procedure and safety instructions before using
the Condux Adjustable Manhole Adapter.
Failure to do so may result in personal injury or
property damage. Save this user’s guide for
future reference.