Comelit MT HDDVR160A - Manual (Page 17)

17
3.3.2 Record stream
Step1: enter into system configuration record configuration record bit rate
Step2: setup rate, resolution, quality, encode and max bit stream
Step3: user can setup all channels with same parameters, tick off “All”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button
to exit current interface.
Note: if the rate value set is over high the maximum resources of the device, the value will be
adjusted automatically.
Definitions and descriptions of Record stream:
Parameter Meaning
Resolution Support 1080P,
FPS 4 CH HD DVR 1080P@7FPS(6FPS)
8 and 16 CH HD DVR 1080P@15FPS(12FPS)
Quality The quality of recorded images. The higher the value is, the
clearer the recorded image is. Six options: lowest, lower,
low, medium, higher and highest.
Encode VBR and CBR
Max bit stream Range from 1536kbps~12288kbps
3.3.3 Time
Step1: enter into system configuration record configuration time; refer to Fig 4-12:
Fig 4-12 record configuration-time
Pre-alarm record time: the record time before event happen i.e. record time before motion detection or
sensor alarm is triggered.