Comelit IPCAM791A - Manual (Page 11)

2 Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the Setup>System>
Maintenance web page (described in User’s Manual, “System > Maintenance”) or use the
Reset button on the network camera, as described below
1. Switch off the Network Camera by disconnecting the power adapter.
2. Press and hold the Reset button with a straightened paperclip while reconnecting the power.
3. Keep the Reset button pressed during about 2 seconds or more than.
4. Release the Reset button.
(IPCAM791A: wait for the Status LED to turn off.)
5. The network camera resets to factory defaults and restarts after completing the factory reset.
When performing a Factory Reset, you will lose any settings you have saved.
(Default IP 192.168.30.220)
Caution:
Reset Button
Reset Button
On Board
WPS LED
WPS Button
[IPCAM791A] [IPCAM794A]
3 More information
For more information, please see the Network Camera User’s Manual, which is available on the
CD included in this package.