Comelit FT SB 09 INT - Manual (Page 13)

FT SB 09
13 FT SB 09
EN
1A 1B
CALL OPERATING
* SIMPLEBUS
SIMPLEBUS TOP
CALL OPERATING
* SIMPLEBUS
SIMPLEBUS TOP
CALL OPERATING
* SIMPLEBUS
SIMPLEBUS TOP
NAME DIRECTORY
ACCESS CONTROL
SETTINGS
* STANDARD
INDIRECT CODES
ALPHANUMERIC
* ALPHANUMERIC
IMMOTEC STAND.
IMMOTEC INDIRECT
2 connect the keystone jack to the terminal;
3 set the type of system as follows:
DISPLAY DESCRIPTION OPERATION
During this setup stage,
make sure that the audio
or audio/video keystone
jack is also in
programming mode. Configuration mode has
been accessed (see point 3
in FT SB 09, page 11).
Select the CALL
OPERATING/SETTINGS
menu.
Select the desired system
mode
using the
keys.
Press the key to
confirm the selection.
5 When the setting procedure is complete, set the programming slide control back to
its standby position (switch in (white) position, see Fig. 1B, page 13).
12.2) Setting the CALL MODE
12.2A) SIMPLEBUS - STANDARD call mode (default).
In this operating mode, the door-entry phone user is identified by a User Name field and
a Code field no longer than 3 digits (between 1 and 240).
EXAMPLE: User name = Smith; Code = 1
12.2B) SIMPLEBUS TOP - STANDARD call mode
In this operating mode, the door-entry phone user is identified by the User Name field
(optional) and a Code field consisting of two parts: zone field with no more than 3 digits
(between 1 and 500) and a user field which must have 3 digits (between 1 and 240).
EXAMPLE: User name = Smith; Code = 25 015;
4 Next, set the call mode (see point 9.2 “Setting the CALL MODE”, page 13) as follows:
DISPLAY DESCRIPTION OPERATION
Press the key to
confirm the selection.
Select the desired call
mode
using the
keys.