Operating controls, inputs and outputs, Off auto on, Subwoofer level – Cambridge SoundWorks BassCube 10S Powered Subwoofers User Manual
Page 6: Line level inputs, Speaker level inputs
6
1. OFF AUTO ON
Set this switch to
AUTO
for normal use. The sub-
woofer will “power up” rapidly when an audio signal
is sensed. The subwoofer will revert to a standby
mode after about 15 minutes of no signal. The stand-
by mode uses less power. Set this switch to
ON
should you wish to prevent the subwoofer from enter-
ing its standby mode.
2. SUBWOOFER LEVEL
This control sets the overall output level of
the subwoofer.
OPERATING CONTROLS, INPUTS AND OUTPUTS
1
3. LINE LEVEL INPUTS
The Subwoofer Out (or preamplifier outputs) from
your audio system connect to these inputs.
4. SPEAKER LEVEL INPUTS
If you do not have, or do not wish to use a line level
output from your audio system, you can connect
speaker wire from your audio system’s left and right
speaker outputs to these inputs.
SUBWOOFER
LEVEL
LOW PASS
FREQUENCY (Hz)
R
MONO
L
LINE
LEVEL
INPUTS
R
L
SPEAKER LEVEL INPUTS
+
+
OUT TO SPEAKERS
5
4
3
2
1
0
6
7
8
9
10
OFF
ON
AUTO
80
100
160
200
R
L
+
+
120
POWER
RED – STANDBY
GREEN – ON
*
*
SET LOW PASS FREQ HERE
WHEN USING 5.1 CHANNEL
HOME THEATER SUB OUT
7
2
3
6
5
4
BassCube 8S Back Panel Diagram