Cambridge SoundWorks S200 MultiPole Surround Speakers - Manual (Page 9)

9 9
S200:
Dimensions: 7"H x 11"W x 5 3/4"D
Weight: 5 pounds each
S300:
Dimensions: 7"H x 11"W x 5 3/4"D
Weight: 6 pounds each
The S200 and S300 can be safely used with any sur-
round receiver rated above 25 watts per channel.
There is little advantage gained in using more power
than 100 watts per surround channel, but amplifiers
above this power rating can be used so long as the
receiver is not operated at distorted levels.
Warning About Excessive Amplifier Distortion
Operating a receiver (of any power rating) beyond its
maximum undistorted output level creates distortion—
added high-frequency sound not part of the musical
program. Distortion dramatically increases the internal
operating temperature of a loudspeaker and will even-
tually cause the speaker’s failure due to burned or
melted internal parts. While Cambridge SoundWorks
includes the most heat-tolerant parts commensurate
with good acoustic design, the speaker’s Limited
Warranty against defects in materials or workmanship
does not apply to parts that fail from long-term
operation at very high temperatures
Enclosure Cleaning
The speaker enclosures can be cleaned with a
window-cleaning product. Use a soft, lint-free cloth
only. Avoid spraying any cleaner on the grille panels.
Brush or vacuum the grille panels if dust accumulates
on them.
SPECIFICATIONS
Speaker Size Setting in Dolby Digital
Decoders
The S200 and S300 include internal high-pass
networks that prevent them from responding to low-
frequency signals below their operation range.
When connecting either speaker to a Dolby Digital
decoder, set the decoders rear channel size setting to
SMALL. If there is a crossover frequency choice, set
at 100 Hz or lower.