C.B.S. Scientific EPS-3000P-IIV - Manual (Page 10)

EPS-3000P-II(V) Manual www.cbsscientific.com 10
entering a new value. The EPS-3000P-II(V) will not accept any parameter outside of the allowed
range. Press Clear to re-enter an appropriate value. When all the parameters of the step are as
desired, press Exit to return to the step screen. The newly entered parameters will be displayed in
the selected step. To add a step after the selected step press the function key labeled ADD. Enter
parameters for the step as for EDIT, pressing Exit when complete.
To delete a program or step, press the Clear key from the program or step screen as desired. After
confirmation the EPS-3000P-II(V) will remove the selected program or step from memory.
Cleaning
Before cleaning the unit, be sure to always turn off AC power using the switch at the rear of the unit,
and then disconnecting the AC line cord. The front of the unit is sealed and can be wiped clean with
any mild detergent solution. Avoid harsh cleaners or agents as they may deteriorate the surface of the
tactile membrane keys.
Method 1 Next
2 steps Prev
Edit
Navigation and editing keys
Method 1 - 1/2 Next
100V / 200mA Prev
150W / 0 C Add
0:10 Edit
Method number
Number of steps
Figure 2. Program screen
Figure 3. Step screen
Method number
Navigation and editing keys
Step 1 of 2
Step parameters:
the setpoint is
reverse video