C.B.S. Scientific SGE-040-02 - Manual (Page 12)

C.B.S.  Scientific Econo-Sub Units 12
SECTION 5
Maintenance of Equipment
5.1 Care and Handling
The plastic components of the Econo-Sub units are fabricated from acrylic and polycarbonate.
Electrodes and connectors are made from pure platinum, stainless steel, and chrome plated brass.
As with any laboratory instrument, adequate care ensures consistent and reliable performance.
After each use, rinse buffer chamber, gel tray and combs with de-ionized water. Wipe dry with a
soft cloth or paper towel, or allow to air dry. Whenever necessary, all components may be
washed gently with water and a non-abrasive detergent, and rinsed and dried as above. Never
use abrasive cleaners, glass cleaning sprays or scouring pads to clean the components, as these
will damage the unit and components.
Additional precautions:
• Do not autoclave or dry-heat sterilize the apparatus or components.
• Do not expose the apparatus or components to phenol, acetone, benzene, halogenated
hydrocarbon solvents or alcohols.
• Avoid prolonged exposure of the apparatus or components to UV light.
• Do NOT treat with diethylpyrocarbonate (DEPC)-treated water for extended periods at
37°C. A brief rinse with DEPC-water is sufficient after a thorough wash.
5.2 Maintenance
The following inspection and maintenance procedures will help maintain the safety and reliable
performance of the Econo-Sub systems. Replacement parts can be ordered by calling 1-858-755-
4959 or by contacting your local distributor.
• Banana plugs and power cords should be inspected regularly. If the banana plugs
become loose or do not feel friction tight replace the plugs or power cords.
• Should power cord assemblies (connectors, wire or shrouds) show any signs of wear or
damage (e.g. cracks, nicks, abrasions, or melted insulation), replace them immediately.
• The platinum wire is secured to the banana jack by compression between a stainless
washer and the jack nut. The nut/washer interface should be tight and free of corrosion.