BLITZ Throttle Controller - Manual (Page 9)

(7) Please read again before driving
※ On AT vehicles and at high speed, the shifting point may feel different since the throttle is
opened even if the accelerator is not stepped. There fore, this is not a malfunction.
※ The boost characteristic may change on vehicles equipped with force induction system
such as turbo chargers. There is a high possibility that the boost has to be readjusted on
vehicles that have been boosted up or the turbo has been changed.
※ As a safety function, this product is configured to turn OFF itself every time the engine is
turned OFF. For example, the engine is turned OFF while it is set at SP3. It will be set at
SP3 once the engine is turned ON and the driver powers ON the throttle controller.
However there is an exception. In a situation when the driver turns the engine OFF after
turning OFF the throttle controller that was set at SP3 mode. It will be set as OFF after
the engine is turner ON. However, it will not be set at SP3 after turning ON the throttle
controller. Instead it will be set as ECO. This is not a malfunction.
CAUTION
It is very dangerous in a situation when the vehicle goes to Fail Safe Mode and
the engine does not rev up. Stop the vehicle at a safe location, shut the engine
OFF, wait for 5 minutes and then start the engine again.
【Unstable engine idle】
※ Is the “Activation Indicator” at the controller lighted when the gas pedal is not stepped?
If it is lighted, the activation point (when the throttle controller is activated) has to be
adjusted. Contact the dealer or distributor who you purchased it from.
※ In a situation that the battery has been disconnected for installation, there is a possibility
that “Idling Learning” is necessary. Please consult at a car dealer.
【Display not turning OFF for a while after shutting the engine off】
※ There are times that the display does not turn OFF after the ignition is turned OFF. The
reason for this is because minute amount of electricity flow is left at the sensor. This is
not a malfunction. However, contact the dealer or distributor who you purchased it from if
the display does not turn OFF for over 30 minutes. (On some Nissan and Infiniti, the
display will take about 30 minutes to turn OFF. The display will turn off in about 5
minutes on 07/10 Honda Fit)
【Light up of Engine Check Lamp, Engine Failure】
※ Verify the contact of the connectors, wiring and direction of the connectors.
※ Change the location where the power was taken from, if it was taken from a +12V ACC
or the voltage is not +12V.
※ There is a connector similar to the accelerator sensor in the engine compartment and it
will not operate properly if it is connected to it. Make sure to connect it to the accelerator
sensor at the interior of the vehicle. (There is an exception on some vehicles that it has
to be connected at the engine compartment)
【Light up of engine check lamp because of installation error】
(8) Trouble Shooting
(9) Regarding reverse cancel harness
It is an optional harness that deactivated the Throttle controller when in reverse.
(Sold separately)
It is connected to the 10th PIN at the controller and to the vehicle’s +12V reverse
switch.
Code No. 14966. Reverse Cancel Harness
Turn OFF the Throttle Controller OFF when reversing for parking.
9