BLITZ R-VIT DS - Manual (Page 6)

In order to operate this product properly and safely, please read this intallation manual/application chart and also
vehicle’s monitor operation instruction, before installation/operation.
Also, for this products and other oprtional equipments, please read each individual instruction manuals.
■About This Product
Option: Code17551 ＴＶ ＪＵＭＰＥＲ ＤＶ
Code17552 ＴＶ-ＮＡＶＩ ＪＵＭＰＥＲ ＤＶ
Vehicle specific harnesses are sold separately.
To view the information while driving, please set the monitor so that video/audio input is displayed/played
while driving. TV JUMPER which enable the function is available, however, TV JUMPER is not available for
all vehicle types.For application, please check our website. (http://www.blitz.co.jp )
Note
This product is monitoring system designed for vihicles : 2003 or later CAN-BUS system equipped Toyota cars, and
vehicles with 1996 or later ISO14230 equivelant diagnostic connector.
Monitored ECU information is displayed on vehicle moniter through supplied video/audio cables.
①Easy, simple Installation
Plugs direcltly into vehicle diagnostic connector.
Video/Audio signals are connected to vehicle monitor using enclosed Video/Audio cable.
②Flash Memory
By employing the flash memory, R-VIT DS is ready for the future software update.
In case that the vehicle monitor is not equipped with external video/audio input, additional input harness is
required to connect to the monitor. (Sold separately)
We cannot confirm the compatibility of the monitor even if R-VIT DS is applicable to the vehicle,
Note
③External equipment ready
Update such as additional BLITZ boost controller is possible using EXT connection.
④Up to 6 informatuion can be displayed out of more than 30 kinds of information available
This depends on vehicle type. Please refer to application chart.
⑤Can display fuel milage status
This depends on vehicle type. Please refer to application chart.
⑥Card type remote control
Easy to operate with included remote controller.
Please refer to “Switch Operation”. (Page.11-12)
（Remote Controller）
IR sending port
PEAK CLEAR ＢＡＣＫ
ＵＰ
ＤＯＷＮ
ＲＩＧＨＴ ＬＥＦＴ
ＥＮＴＥＲ
ＲＥＣ
ＰＬＡＹ
ＳＴＯＰ
ＭＡＰ
ＥＳＣ１
ＥＳＣ２ ①Connection established: ON
②Connection is NOT established: FLASH
Note: Connection with ECU,
not external equipments
LED display pattern
（Front）
IR receiving port
Mode LED
Audio R S Video Audio L Video
External equipments connector
（Back）
（Side）
－ Important Notice －
５