BLACKHAWK! BREACHERSGRIP SHOTGUN STOCK - Manual (Page 2)

Installation Instructions
Page 1
www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
ATTENTION: Read and follow all instructions and warnings prior to installation and/or
firing a BreachersGrip equipped shotgun. Take extra time to review the shooting tips
& techniques section of this manual. If you are at all unsure of your ability to install
your BreachersGrip stock safely, please seek the services of a competent gunsmith.
WARNING: Before beginning stock installation, make sure that the shotgun is
UNLOADED. Carefully check the chamber and magazine tube making both visual and
touch verification.
WARNING: The Knoxx BreachersGrip is NOT compatible with the
Mossberg 590 DA. Use of the BreachersGrip with the Mossberg 590 DA will cause
product failure and possible injury.
WARNING: Remington 870 BreachersGrip CAN NOT be used with oversized or
extended safeties. Oversized or extended safeties will cause product failure and possi-
ble injury. Contact BLACKHAWK! customer service for recommended safety options.
NOTICE: The BreachersGrip is not compatible with the FN "Tactical" Shotgun. Prior to
installing a BreachersGrip the "Tactical" trigger group must be replaced with a
standard Winchester 1300/FN Police trigger group. Contact Winchester or FN for
replacement trigger group.
TOOLS REQUIRED:
•
Socket Wrench, Long Extension and Sockets
• Medium Phillips Screwdriver
• Large Flat Blade Screwdriver
• Extended “Ball End” Allen Wrench
Remington 3/16” (SAE) - Moss., Win., FN 1/4” (SAE)
Upgraded allen wrench is available from BLACKHAWK!
1. Remove original stock. Refer to manufacturer’s instructions for the best method to
remove stock. Normally the pad is held in place by two Phillips screws and the stock
is held on by one bolt. Remove the pad by unscrewing the Phillips screws and remove
the stock bolt to free the stock from the shotgun. (Fig. 1) Remington owners: Remove
any metal spacers from the back of the receiver.
Fig. 1