BLACKHAWK! AXIOM RUGER 10/22 RIFLE STOCK - Manual (Page 2)

INSTALLATION INSTRUCTIONS:
WARNING: READ THESE INSTRUCTIONS AND OTHER WARNINGS BEFORE ATTEMPTING TO INSTALL THIS
STOCK ON YOUR FIREARM
1. With the firearm pointing in a safe direction and your fingers outside the trigger guard, remove the magazine, open the
bolt and both visually and by touch, make certain there is not a cartridge in the chamber.
2. Allow the bolt to close.
3. Remove the screw located on the bottom side of firearm and set it aside as it will be used with your
BLACKHAWK! Stock.
4. Position the safety so that an equal amount of the button is exposed on each side of the receiver. If the safety is not in the
middle when the barrel-receiver assembly is lifted out of the stock, the stock will be damaged.
5. Keeping your hand away from the muzzle, grasp the barrel and swing the barrel-receiver assembly upward and forward
(away) from the forearm of the stock.
6. Be careful the two receiver cross pins and bolt stop pin do not fall out.
7. Prior to stock installation, remove any spacers located in stock receiver opening. Install the barrel-receiver into your
BLACKHAWK! Stock by following, in reverse order, Steps 1-6 while making sure that once again the safety button is
centered within the receiver and that the Receiver or “Action” Lug seats properly into the corresponding recess within the
BLACKHAWK! Stock. Re-install factory stock bolt and tighten. (fig. 8a, 8b)
fig. 8a fig. 8b
www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
PGIG002KX
PGIG002KX.qxd:Layout 1 9/11/09 10:04 AM Page 1