Beckett AQUASMART 7600WTM - Manual (Page 3)

AquaSmart Wireless Termperature Module Manual 3
Approvals
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy, and if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment OFF and ON, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
1.
2.
3.
4.
To satisfy FCC RF Exposure
requirements for mobile
and base station transmission devices, a
separation distance of 20cm (8”) or more
should be maintained between the antenna
of this device and persons during operation.
To ensure compliance, operation at closer
than this distance is not recommended.
The antenna(s) used for this transmitter must
not be co-located or operating in conjunction
with any other antenna or transmitter.
Figure 1 - Outdoor Temperature Reset Curve
High Limit
Setting
Minimum
Reset
Temperature
Low
OAT
High
OAT
RESET
TEMPERATURE
OUTDOOR AIR
TEMPERATURE
(OAT)
This device complies with Industry Canada
license - exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) This device may not cause
interference, and (2) this device must
accept any interference, including
interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux
appareils radio exempts de licence.
L’exploitation est autorisée aux deux
conditions suivantes: (1) l’appareil ne doit
pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d’en
compromettre le fonctionnement.