Autoquip FREIGHTLIFT FLH - Manual (Page 4)

4
Your FREIGHTLIFT arrives packaged as follows: The two (2) masts with
cylinders/sheaves/cable, and platform come banded together, you also receive parts
crates/boxes which normally contain the smaller of the following items:
The following items are typically shipped within each FREIGHTLIFT order:
A. Two Carriage Upright Assemblies
B. Four Carriage Side Guards (Handrails)
C. Two Upper & Two Lower Guide Wheel Assemblies
D. Two Tension Roller Assemblies
E. One Overhead Channel
F. One Mast Cross Channel
G. Two (minimum) Horizontal Brace Channels
(and miscellaneous lengths of channel for bracing)
H. One Hydraulic Power Unit, One Control Panel, Two (min.) P/B
I. Three 20' lengths of Pressure Hose and Fittings
J. One 50' length of Breather Tube and Fittings
(and miscellaneous Hardware, Manuals, and Signs)
NOTE: The “Bill of Lading” will state the number of pieces shipped. TWO ITEMS
MAY BE BANDED TOGETHER AND COUNT AS ONE PIECE.
Upon receipt of the shipment, check for exposed damage or shortages and make note
of it on the trucking company Bill of Lading or the Shipping Papers. Reports of
concealed damage to items contained in crates must be reported within 48 hours. DO
NOT destroy the crating while opening it to inspect the contents. If damage is
suspected or found, report it directly to the carrier. DO NOT contact Autoquip
Corporation!! All shipments are FOB from the Autoquip plant. Any claims for damage
must be filed with the carrier. Any parts shipped from Autoquip that are intended
to replace damaged or lost items will be invoiced to the ordering party.
Assuming no damage has occurred to the crate, check the components against the
packing list. This will provide assurance that every item shipped has been received.
Everything needed for the installation should be available. If not, report any shortages to
Autoquip Corporation within 10 days. (Autoquip is not responsible for parts lost, stolen
or damaged during transportation, storage, installation, or during any other
circumstances or conditions that may be beyond Autoquip’s control.)
INSPECTION & IDENTIFICATION