Autoquip FREIGHTLIFT FLMC - Manual (Page 39)

39
D. RAISING THE BEAMS & WHEEL GUIDES (Reference Figures 21 through 23)
Items Needed:
Qty
Description
2 Lower Wheel Guides – left & right ( “L” & “R” on the assembly)
1 Installation Angle (with bolts in each end) – if needed
28 1/2" grade 8 Hex Head Cap Screws (length varies) and Washers
1. Raise the beams into position (see Figure 21). The mast beam assemblies are
designated either “left hand side” or, “right hand side” (there is a welded “L” or “R”
marked on the mast beam base plate). The left hand side is to your left and the
right hand side to your right as you stand behind the mast beams (or with your back
against the bracing wall) facing the beams (the guide angles are always on the
outside of the beams).
2. Position the lower wheel blocks into their respective beams by tipping the blocks
and allowing the rollers to fit inside the guide angles. Then, insert the guide wheel
into the opening at the bottom of the beams.
3. Slide the right hand beam into position along side the carriage. Both upper and
lower wheel guide assemblies should align with their respective mounting holes on
the carriage uprights. Bolt the wheel guide assemblies to the uprights using the
1/2" grade 8 bolts and the 1/2" washers that have been provided. Torque all these
bolts to 99 ft. lbs. as shown in Figure 22.
NOTE: Make absolutely sure the beam is secure with chain or temporary
bracing.
WARNING !
Do not depend on the carriage uprights and wheel blocks to support
the beam! Use other means to support and secure the beams in the
raised position during installation and prior to final bracing.
Improperly or inadequately supported beams could fall and cause
serious injury to adjacent personnel or permanent damage to the
equipment.
4. Repeat the previous step to position and secure the left hand beam. Don’t forget to
torque all wheel block bolts to 99 ft. lbs.!
5. The installation angle shipped with your unit can be used to properly space the two
beams apart temporarily, prior to setting the carriage or securing beams to the floor.
INSTALLATION INSTRUCTIONS