Autoquip SERIES 35 TILTERS - Manual (Page 25)

25
WIRING AUTOQUIP "SUPER TORQUE' MOTORS
Because Autoquip "Super-Torque" motors actually deliver substantially more
horsepower than their nameplate rating, they must always be wired for heavier current-
draw than standard motors of the same nameplate rating. However, because of the
"Super-Torque" motor’s starting efficiency and superior running characteristics, circuit
components do not have to be as large as for standard motors of equal delivered
horsepower.
The following chart should be observed in connecting these motors to power sources,
remembering that, where 115-Volt operation is contemplated, the current-draw is too
heavy for plugging into ordinary lighting circuits. Heavy wire must be used all the way to
the power-source.
HP and Source Fuse
Size
Circuit
Breaker
1 _ HP
208-230 V/60 CY/3 PH 15 A 10 A
1 _ HP
460 V/60 CY/ 3 PH 7.5 A 5 A
NOTE: For larger horsepower motors, consult factory.
MOTOR CONNECTION DIAGRAMS
GENERAL MAINTENANCE