Autoquip SERIES 35 MANUAL TURNTABLE - Manual (Page 3)

3
IDENTIFICATION
When ordering parts or requesting information or service on this lift, PLEASE REFER
TO THE MODEL AND SERIAL NUMBER. This information is on a nameplate attached
to the leg assembly. Replacement parts are available from a local Autoquip distributor.
INSPECTION
Immediately upon receipt of the lift, a visual inspection should be made to determine
that it has not been damaged in transit. Any damage found must be noted on the
delivery receipt. In addition to this preliminary inspection, the lift should be carefully
inspected for concealed damage. Any concealed damage found that was not noted on
the delivery receipt should be reported in writing to the delivering carrier within 48 hours.
The following is a checklist that will aid you in the inspection of this lift:
1. Examine entire unit for any signs of mishandling. Pay special attention to the
power unit and PUSH BUTTONS.
2.
Thoroughly examine all connections, making sure they have not vibrated loose
during transit, and inspect wiring for any signs of damage.
3. After installation, raise the lift and inspect the base frame, platform, scissors
assembly, and cylinder plumbing connections.
IDENTIFICATION & INSPECTION