Autoquip SERIES 35 MANUAL TURNTABLE - Manual (Page 14)

14
LOAD CAPACITY
The load capacity rating is stamped on a metal plate attached to one side of the lift.
This figure is a net capacity rating for a lift furnished with the standard platform. The
relief valve of the pumping unit has been set to raise the weight, plus a small amount for
overload. Where gravity roll-sections, special tops, etc, are installed on the lift after
leaving the plant, deduct the weight of these from the load rating to obtain the net
capacity.
DO NOT EXCEED RATED CAPACITY OF THE LIFT. Loading the lift beyond its rated
capacity is unsafe, will shorten the operational life of the lift, and will void its warranty.
Series
35
Model
Capacity
(Lbs.)
Travel
(In.)
Lowered
Height
(In.)
Raised
Height
(In.)
Max
End
Load
(Lbs.)
Max
Side
Load
(Lbs.)
Std Min.
Platform
(In.)
Raise
Time
(sec)
No
of
Cyl
Ship
Wt.
(Lbs.)
24S25 2500 24 6.5 30.5 2500 2500 24 x 36 8 1 500
24S40 4000 24 6.5 30.5 4000 4000 24 x 36 11 1 510
24S60 6000 24 6.5 30.5 4500 4500 24 x 36 16 2 530
24S80 8000 24 7 31 4500 4500 24 X 36 22 2 650
36S15 1500 36 6.5 42.5 1000 750 24 x 36 28 1 450
36S25 2500 36 6.5 42.5 2500 2500 24 x 48 12 1 610
36S40 4000 36 6.5 42.5 3500 3500 24 x 48 17 1 620
36S60 6000 36 6.5 42.5 3500 3500 24 x 48 25 2 650
36S80 8000 36 7 43 3500 3500 24 X 48 34 2 750
48S25 2500 48 7 55 2500 2500 24 x 64 16 1 820
48S40 4000 48 7 55 3500 3500 24 x 64 22 1 830
48S60 6000 48 7 55 3500 3500 24 x 64 33 2 860
48S80 8000 48 7.5 55-1/2 3500 3500 24 X 64 44 2 960
60S25 2500 60 8 68 2500 2500 32 X 87 22 1 1750
60S40 4000 60 8 68 3500 3500 32 X 87 44 2 1800
60S60 6000 60 8 68 3500 3500 32 X 87 44 2 1850
SPECIFICATIONS