Autoquip DOUBLE ARM SCISSOR LIFT TABLE - Manual (Page 14)

SPECIFICATIONS
LOAD CAPACITY
The load capacity rating is stamped on a metal plate attached to one side of the lift.
This figure is a net capacity rating for a lift furnished with the standard platform. The
relief valve of the pumping unit has been set to raise the weight, plus a small amount for
overload. Where gravity roll-sections, special tops, etc, are installed on the lift after
leaving the plant, deduct the weight of these from the load rating to obtain the net
capacity.
DO NOT EXCEED RATED CAPACITY OF THE LIFT. Loading the lift beyond its rated
capacity is unsafe, will shorten the operational life of the lift, and will void its warranty.
14
DANGER!
Do not make modifications to the lift without authorization
from the manufacturer. Autoquip cannot foresee and is
not responsible for injury or damage which results from
the unauthorized modifications or misuse of the lift.
UNBALANCED LOADING
The stabilization provided is basically for balanced loads. If special attachments extend
beyond the length and/or width dimensions of the platform, the end and/or side load
capacity is reduced 2% for each one-inch extension from the center. If the load is
rolling onto the platform (in any but the fully-lowered position) the end and/or side load
capacity is reduced by a 50% impact factor (i.e., divide the rated end/side load by 1.50
to establish an available “axle” load).
PUMP PRESSURE
This lift incorporates a positive displacement pump machined to a high degree of
accuracy and specially adapted to requirements of higher-pressure ranges over that of
a standard pump. Therefore, standard factory models of the same manufacture cannot
replace it.
The pump can operate efficiently at intermittent pressures up to 2000 PSI and
continuous duty to 1500 PSI. The safety relief valve in the pump assembly is factory-
set to stay within the parameters of the pump and lift requirements.