Autoquip SERIES 35 ROVER MOBILE - Manual (Page 23)

23
WARNING !
Before installing lift, read & follow the recommended safety
practices in the Safety Practices section. Failure to follow these
safety practices could result in death or serious injury.
Normally scissors lifts will require very little maintenance. However, a routine
maintenance program could prevent costly replacement of parts and/or downtime.
WARNING!
Do not work under lift without Maintenance Device! To avoid
personal injury, NEVER go under the lift platform until the load
is removed and the scissors mechanism is securely blocked in
the open position and the appropriate OSHA lock-out/tag-out
procedure is followed . See "Lift Blocking Instructions" section.
MONTHLY INSPECTION
1.
Check oil level and add oil as necessary (see recommendations this section).
2.
Check for any visible leaks. Correct as necessary.
3.
Check any unusual noise when it occurs, take any necessary corrective action.
4.
Check snap rings at all rollers. If missing or loose, replace/repair at once.
5.
Check all rollers for signs of wear. Replace as necessary.
6. Do
not grease roller or axles; they have lifetime-lubricated bearings.
7.
Check all wiring for looseness or wear. Repair at once.
8.
Check the set screws which capture cylinder trunnion pins. Tighten as needed.
OIL REQUIREMENTS
Change oil yearly, or more frequently if it darkens materially or feels gummy or gritty.
Do not use hydraulic-jack oil, hydraulic fluids, brake fluids, or automatic transmission
fluid.
ROUTINE MAINTENANCE