Autoquip SERIES 35 ROVER MOBILE - Manual (Page 18)

18
OPTIONAL 115/60 AC UNIT
WARNING!
Read and understand all of the instructions carefully before
proceeding with the installation process.
1. The area where the Rover is to be used must be level, solid, and smooth. The unit
should roll around freely without obstruction.
DANGER !
To avoid personal injury, NEVER use the unit in or around water or
where flammable gasses may be present.
2. Remove the material the lift was shipped in. Remove the banding and the pallet
from under the unit.
3. Plug the power cord into a suitable 20 amp grounded 115/60 receptacle.
4. Test the operation of the lift by pressing the “UP” button. Then push the “DOWN”
button to lower the platform. If the lift does not work, see the “Troubleshooting”
section in this manual.
WARNING!
All warning and information decals should be in place as outlined in
the “Label Identification” section. If decals are missing or damaged,
they should be replaced with new ones. Contact Autoquip for
replacements.
INSTALLATION INSTRUCTIONS