General maintenance, Electrical schematic – Autoquip XLR AIR User Manual
Page 26
26
(WHITE)
(BLACK)
(RED)
(ORANGE)
24V.
L3
L1
L2
L1
L2
3/4 HORSEPOWER
MOTOR:
115 VOLT
1 PHASE
60 CYCLE
(BY OTHERS)
60 CYCLE
115 VOLT
1 PHASE
O.L.
T2
T3
T1
L2
L1
L1
L2
DN. SOL.
ELECTRICAL SCHEMATIC
IDENTIFICATIONS
RED - DOWN SOLENOID
WHITE - MOTOR
BLACK - MOTOR
ELECTRICAL LEAD (PIG TAIL)
CONNECTION No. ON DEVICE.
COLOR CODE
STANDARD PUSHBUTTON
GREEN - EQUIPMENT GROUND
ORANGE - DOWN SOLENOID
(GRN)
(GRN)
115V.
(XF)
LOCATED ON INSIDE OF FRONT COVER.
TRANSFORMER PRIMARY CONNECTION DIAGRAMS ARE
LOOSE WHEN ORDERED. TO BE INSTALLED AND WIRED
3.
OPTIONAL FOOTSWITCH W/ GUARD (NEMA 1) SHIPPED
2.
1.
PRE-WIRED, AND MOUNTED TO POWER UNIT.
MOTOR STARTER, CONTROL TRANSFORMER, OVERLOADS,
AND FUSES TO BE MOUNTED IN NEMA 1 ENCLOSURE,
(WHEN USED)
SWITCH
"UP" LIMIT
CONTACTOR
FOOT SWITCH
(BLUE)
(BLACK)
(BLACK)
(WHITE)
COIL
TYPICAL PILOT CONTROLS ONLY
2.5 AMP FUSE
SEE NOTE #3
PUSHBUTTON
CONTACTS
MOTOR STARTER
MOTOR STARTER
CONTACT
O.L. RELAY
TRANSFORMER
(GRN.)
(BY OTHERS)
FUSED DISCONNECT
(WHITE)
Figure 10 Electric Schematic; 115V/1Ph
GENERAL MAINTENANCE