Autoquip Q-LIFT - Manual (Page 19)

19
Mounting Accordion Skirt On Bevel Toe Guard
Raise one side of skirt along with a skirt-mounting bar (1/8” x
1”) to side of bevel toe guard. When possible, center skirt-
mounting collar and skirt-mounting bar (1/8” x1”) on platform
bevel toe guard.
Align pre-drilled holes in bevel toe guard with skirt-mounting
bar holes and punch holes in skirt-mounting collar.
Push a nylon drive rivet through each hole in skirt-mounting
bar. Hammer aluminum pin into rivet until flush with rivet
head. Repeat mounting process for remaining sides of
accordion skirt.
4. Install weight rods into weight rod pockets at bottom of accordion skirt. Install spring tempered wire
rods into pocket of black convolutions.