Bryston 2BSST - Manual (Page 4)

2BSST TWO CHANNEL POWER AMPLIFIER
2
REMOTE POWER CONTROL ~ 12 VOLT TRIGGER CONNECTOR:
The 2BSST may be powered on or off using a 12 volt A/C or D/C voltage by using the rear panel 4 position
screw terminal connector. Insert the 12 volt wires into the input labeled ‘IN’ (polarity is not important). The
power amplifier will now power on when a 12 volt trigger voltage is applied or off when removed. This same
trigger voltage is available at the connector positions labeled ‘OUT’ after the 2B SST has completely powered
up. This voltage can then be used to power another 12 volt device. This feature allows sequencing of your
power amps without large turn-on surges.
IMPORTANT: the front panel power switch must be OFF in order for the 12 volt trigger feature to work.
VARIOUS SPEAKER WIRE TERMINATIONS AMPLIFIER OUTPUT BINDING POSTS
FOR CONNECTING SPEAKERS