ArcOne Auto-Darkening Filters (Vision Python & Carrera) Europe - Manual (Page 5)

- 4 -
Care and Maintenance
NOTE: Replacement components must be used in accordance with these instructions.
Failure to use ArcOne ® replacement components in accordance with these instructions
voids certification of this product.
Filters:
Filters require virtually no maintenance other than periodic cleaning when the lens, solar panel,
and/or sensor(s) become dirty or clouded from smoke. Clean your filter by using window cleaner
or a mild soapy solution and a soft cloth or paper towel (do not immerse in water or solution).
Change the cover plates frequently. Storage Temperature -10 - 38°C (14 - 100°F)
Models with a replaceable battery will need the battery changed periodically when the Low
battery LED/LCD indicates.
Welding Helmets:
Welding helmets require virtually no maintenance other than periodic cleaning when dirty. Clean
your helmet by using a mild soapy solution and a soft cloth or paper towel (do not immerse in
water or solution).
DO NOT throw or abuse the helmet. Doing so may crack the helmet shell and compromise the
protection.
Polycarbonate Protection (Cover) Plates:
Change cover plates when they lose flexibility and/or become bowed or distorted. Clean with
mild soapy solution including any build-up from the area where the cover plate is retained.
Discard if cleaning fails to improve visibility or cracks, scratches, etc. impair visibility.
Storage:
Equipment may be stored in original packaging or similar packaging. Store in a safe and dry
location away from direct heat.
Spatter Protection
SPATTER DAMAGE IS NOT COVERED BY WARRANTY
Ensure that the helmet is always equipped with an Outside Cover Lens (in front of the filter, on
the outside of the helmet) and an Inner Cover Lens (behind the filter, on the inside of the
helmet). These protection lenses must be replaced if broken, warped, damaged, or covered with
welding spatter such that vision is impaired. Replace regularly only with ArcOne ® cover plates.
All helmets use 1 mm thick cover plates.
Parts Selection Guide
Headgear
02-HG
Includes sweatband (not shown) •
Height Adjustment (Snap Out/ Slide/ Snap In) •
Circumference Adjustment (Ratchet Push/Turn) •
Angle Adjustment (Pivot Stop) •
06-HG
Includes sweatband (not shown) •
Height Adjustment (Snap Out/ Slide/ Snap In) •
Circumference Adjustment (Ratchet Push/Turn) •
Angle Adjustment (Pivot Stop) •
Horizontal Adjustment (Slide Forward) •
Ratchet
Knob Ratchet
Knob
Height Adjustment
Pivot Stop
Horizontal
Adjustment