Bulldog Security RS82 - Manual (Page 8)

7
MODEL RS85 OPERATOR PROGRAMMING INSTRUCTIONS
ALL OF THE FUNCTIONS AND PROGRAMMING OF THE RS82, PLUS:
Programming to Start your Vehicle with your Factory Keyless Entry
Press and hold the brake, press and hold Button #1 on the Bulldog Security remote until the parking lights
flash once (if connected) or for approximately six (6) seconds or until the unit clicks or flashes. Release.
Press Button #2. The parking lights will flash once (if connected). NOTE: A relay Part #775 is required to
make this operate using the factory keyless transmitter. The relay is required to convert the positive door
lock signal to a negative output for the RS85.
Programming for Aftermarket Alarm Starting
Press and hold the brake, press and hold Button #1 on the Bulldog Security remote until the parking lights
flash once (if connected) or press and hold this button for approximately six (6) seconds. Release. Press
Button #2 the parking lights will flash twice (if connected). The unit is now programmed for starting from
your aftermarket alarm.
AUXILIARY INPUT (For Model RS85 Only)
(For your factory keyless or aftermarket alarm)
When connecting this unit to a factory keyless entry system, you must locate the door lock wire that
tests as a positive when you press the lock button on the factory remote. A relay Part #775 will be
needed to convert the positive output from the door lock to a negative for the RS85. If the wire negative
when you press the lock button on the factory remote, you can tie directly into the BLUE wire.
This wire is usually located in the driver’s kick panel in the harness that is coming from the driver’s
door.
BUTTON #1
Remote starts your
vehicle from up to 400
feet away.
BUTTON #2
Turns off your remote
starter.
2 1
BULLDOG
HOW TO USE YOUR REMOTE TRANSMITTER
Start
Press and release Button #1 the vehicle will remote start.
Stop
Press and release Button #2 the vehicle will shut down.
Pit Stop: Exiting the Car with the Engine Running
Make sure the transmission is in park and the brake is not
pressed then press and release Button #1 (start) before turning
the ignition switch off. (The engine will remain running for
15 minutes or until the brake is pressed.)
(Model RS85 Only)
Start
Using the remote included in this kit: Press and release Button #1.
Using your factory keyless entry remote: Press the Lock button three times.
Using Aftermarket Alarm: Press the second channel button on your remote transmitter.
Stop
Using the remote included in this kit: Press Button #2.
Using your factory keyless entry remote: Press Lock button.
Using Aftermarket Alarm: Press and release the second channel button on your remote transmitter.
Pit Stop (Exiting the Car with the Engine Running)
With your factory keyless remote:
If the vehicle is running with the ignition key, a press to Lock button on the factory keyless will cause the parking
lights to flash once (if connected). You can now turn off your ignition key, remove the key and exit the vehicle. The
vehicle will remain running for 15 minutes. NOTE: Some vehicle’s factory keyless won’t work if the engine is running.
If your vehicle operates in this fashion, pit stop will not function.