Allen&Heath iDR-16 - Manual (Page 5)

iDR MixRack Getting Started Guide 5 AP7445 iss.4
Front Panel
Mic/Line inputs High performance, recallable
analogue preamps for balanced or unbalanced
microphone and line level signals. Gain, Pad
and 48V are digitally controlled within the
preamp. Digital Trim and Polarity is available
within the DSP channel.
Inputs are identified by Slot (card position) and
Socket (number), for example A1 or C8. Any
input can be patched to any DSP channel
using the PREAMP screen.
Line outputs Line level, balanced XLR
outputs. Nominal level +4dBu with +22dBu
maximum providing +18dB headroom.
iLive signals can be patched to any output
socket using the OUTPUTS screen. The
outputs are relay protected to prevent power
on or off thumps.
PL-Anet RS485 connection for Allen & Heath
PL Series remote controllers. Several may be
daisy chained together or routed individually
via the PL-9 PL-Anet hub. PL controls can be
assigned using the SURFACE SETUP screen
or Editor software.
MIDI IN and OUT sockets.
MIDI is tunnelled via ACE™
or Network to the MIDI port
at the Surface. For more
information about MIDI
refer to the iLive MIDI
Specification.
Network Built-in 3 port switch. Connect one or more laptops
running iLive Editor, a wireless router, other iLive systems or
external network, or link control to a Surface not equipped
with ACE™. All devices on the network must have
compatible TCP/IP addresses. A recessed switch lets you
reset the network settings to factory default.
ACE™ MixRack to Surface link Also used when linking a
Slave MixRack to a Master in Dual-Rack expansion mode. A
single CAT5 cable links audio and control. You do not need
a separate Network cable because control is bridged over
the ACE™ cable between MixRack and Surface.
PHONES ¼” stereo socket and level control
for the built-in headphone amplifier. The
output follows the PAFL selection.
Port B audio network option slot Fit one of
the option cards available for system
expansion, digital mic splitting, recording and
distributed audio networking. Capable of bi-
directional 64 channels, 48kHz sampling rate.
Current options include ACE™, Dante,
EtherSound, MADI, MMO, Waves. Refer to the
A&H web site for more on the available options.
SYSTEM LOCK indicates MixRack digital audio sync lock.
Rack Ears Fit into a
19” rack or flightcase.
PL-9 hub
AES digital out option Shown
fitted in the last card position.
Each socket handles two signals,
in this case 5-6 and 7-8.