Allen&Heath MixWizard3 14-4-2 - Manual (Page 24)

24 WZ 3 14:4:2 User Guide
REMOVE SIDE TRIMS
REMOVE M4 POZI SCREW PER SIDE
ROTATE POD
REMOVE 4x M3 TORX SCREWS
REMOVE 4x M4 POZI SCREWS PER SIDE
REMOVE 3x M3 TORX SCREWS
ROTATE POD
LIFT OFF BASE
MONO INPUT STEREO INPUT
GROUP
MASTER R
DIRECT OUT PRE/POST FADER
AUX PRE/POST INSERT/EQ
AUX PRE/POST FADER
AUX PRE/POST FADER
AUX STEREO/MONO
MASTER L
MATRIX AB
BALANCE
AUX 1-4
BALANCE
AUX5
BALANCE
TB MIC
+48V
AUX6
BALANCE
User Options
The MixWizard has a versatile architecture which
should satisfy most applications you may encounter
without modification. However, the following internal
options provide alternative settings for those
applications that may demand them. Access is
required to the internal assemblies. For user
convenience, pluggable jumper links are used in
most places.
Remove the base Start by removing the side
trims if fitted using a Pozi crosshead screwdriver.
Release the two M4 Pozi head pod securing screws
and rotate the connector pod to gain access to the
three M3 rear base fixing screws. Use a Torx
starhead screwdriver to remove these. Rotate the
pod again to remove the four M3 underside base
screws using the Torx driver. Carefully lift off the
base.
Configure the internal options Fit the
options required. Set the option jumpers to the
required positions. Make sure they are pressed fully
home. Check that all channels are correctly set and
all options fitted according to their instructions. Make
sure that no debris or parts are left loose inside the
console.
Refit the base Carefully reposition the base.
Refit the fixing screws. Lock the connector pod in
the required position using the securing screws.
Refit the side trims if required.
IMPORTANT: Check carefully that all channel
jumpers are correctly set as required. Errors on one
or more channels now may cause user problems
later. We recommend that you write the repositioned
jumper settings on a label and adhere this to the rear
panel. This would provide a helpful reference to
other users of the console.