Allen&Heath RPS10 - Manual (Page 7)

7
Servicing
THIS UNIT CONTAINS NO USER SERVICEABLE PARTS. REFER ALL SERVICING TO A
QUALIFIED SERVICE ENGINEER, THROUGH THE APPROPRIATE ALLEN & HEATH DEALER
Initial operational tests on the power supply can be carried out by switching the unit ON and checking the front panel neon
indicator is illuminated. If the neon indicator is not illuminated, check the fuses are intact in the mains plug (where fitted) and the
front panel fuseholder.
THIS OPERATION SHOULD ONLY BE CARRIED OUT BY A TECHNICALLY COMPETENT
PERSONNEL
If the front panel neon indicator is illuminated but the console appears not to have any power then it may be necessary to check the
voltages present on the output connector. Refer to the Technical Specification section in this manual for the DC output voltage
levels.
Any fault condition, with the exception of simple mains fuse failure, will require access to the internal assemblies of the power
supply.
Servicing Components
ALL SERVICE AND REPAIR WORK MUST ONLY BE CARRIED BY TECHNICALLY COMPETENT
PERSONNEL
REPLACEMENT OF ANY COMPONENTS SHOULD BE UNDERTAKEN ONLY AFTER
DISCONNECTING THE MAINS SUPPLY LEAD FROM THE POWER SUPPLY UNIT
The RPS10 power supply unit requires no internal maintenance or regular servicing. If the RPS10 requires servicing or repair then
refer to the relevant service manual for the power supply information.