Allen&Heath WZ16 2 - Manual (Page 6)

WZ16:2 U
SER
G
UIDE
6
101.6
165.1
101.6
37.7
482.6 (19"RACK)
443.7
(10U)
193
75
13
65
192
I
NSTALLING THE
C
ONSOLE
The MixWizard Series features the ALLEN & HEATH Quick Change Connector
(QCC) system. The rear connector pod may be hinged and locked into either
of two positions: Rear connectors for desktop operation with the control panel
sloped at a convenient 15 degrees, or Underside connectors for 19" rack
mounting in a compact 10U space. The connector position can be easily
changed at any time to fit your application.
Using a suitable
screwdriver, mount the
console in the rack using
4x M6 bolts and M6 caged
nuts on each side for
maximum strength. We
recommend you fit the
bolts with plastic cup
washers to protect the
panel. Ensure adequate
ventilation by allowing a
minimum clearance of
25mm around all sides for
unimpeded air flow.
To change the position
remove the crosshead
locking screw on each side,
swing the connector pod
into position, and refit the
two screws.
Do not transport or carry the
console with the locking screws
removed.
Do not attempt to remove the
connector pod from the console.
19" R
ACK
M
OUNTING
D
ESKTOP
O
PERATION
The console can be easily
flightcased in either
connector mode. Provide
the dimensions shown here
to your flightcase supplier.
F
LIGHTCASING
The console is fitted with rubber
feet to ensure it does not slip or
scratch the work surface. The
control panel is angled at 15
degrees for operating convenience.
Not Suitable For In-Wall Mounting