Allen&Heath WZ20 8 2 SERVICE MANUAL - Manual (Page 11)

ALLEN & HEATH 2E-8SM 10
Channel Pre-Fade Aux Send Options
The pre-fade sends are set post-EQ and post-ON as standard. However, link options on each channel assembly allow
pre-EQ and/or pre-ON if required. Refer to the diagram below.
Channel Direct Output Source
The direct outputs are sourced post-fader as standard. A link option is available per channel to select a pre-fade
source. Refer to the diagram below.
INTERNAL LINK OPTIONS
The console is set to satisfy most applications that should be encountered. However, the following internal link options
are offered to provide alternative settings for those applications that may require them. Access to the options requires
the removal of the rear covers depending on which option settings are to be altered. Refer to the section for removing
circuit board assembly on which the link option is located. Some options involve the cutting of circuit board tracks and
soldering of circuit board links and should only be carried out by competent technical personnel. Further information
is available from ALLEN & HEATH if required.
CONNECTOR CIRCUIT
BOARD ASSEMBLY
MONO INPUT CIRCUIT BOARD
ASSEMBLIES
X8
Unit inverted with the base and connector cover removed.
STEREO INPUT CIRCUIT BOARD
ASSEMBLIES
X6
LEFT
RIGHT
DAUGHTER CIRCUIT BOARD
ASSEMBLY
X1