Aladdin Light Lift ALL700-CM(Two Circuit Fixtures Only) - Manual (Page 5)

STEP 7
Position ALL700 where ceiling box will be centered in ceiling hole. Weight and bottom contact plate
assembly should hang down through ceiling hole. Adjustments can be made loosening 3/8” channel strut
bolts that hold ALL700 to channel struts. Retighten channel strut bolts after adjustments are made.
Confirm channel strut nuts are seated properly. See Diagram C.
Never adjust the channel struts improperly. This could cause the chandelier to fall, which could cause
death, personal injury, and/or property damage.
Conduit Coupler
Bottom Set Screw
3/32” Allen Wrench
STEP 8
Adjust ceiling box elevation up or down to be flush with sheetrock. Use 3/32” Allen wrench on conduit
coupler to loosen bottom set screw. Conduit assembly is telescopic. The ceiling box should not touch inside
of ceiling hole. Retighten bottom set screw on conduit coupler and confirm top set screw is tight. See
Diagram D.
Never attach or adjust the conduit assembly improperly. This could interfere with the automatic shutoff
system and could cause the chandelier to fall, which could cause death, personal injury, and/or property
damage.
Diagram C 3/8” Channel Strut
Adjustment Bolts
3/8” Channel Strut
Adjustment Bolts
Diagram D
4 1/2” Hole
Conduit Coupler
Top Set Screw
3/32” Allen
Wrench
Sheetrock Sheetrock