AirLive IP-200PHD-24 - Manual (Page 20)

2. Getting Started
15 AirLive IP-200PHD-24/IP-200PHD-24B
User’s Manual
(1) Enable UPnP option of your NAT router
To use UPnP IGD function (NAT traversal), you need to make sure the
UPnP function is enabled in your router. Most new home routers should
support this function. Some of routers are default enable and others are
not. Please check user’s manual of your NAT router for detail.
(2) Enable UPnP NAT traversal option of the Network Camera
Refer to Setting
Î Network Î UPnP page for detail NAT traversal
setting. Note that this option is default enabled.
(3) Access your Network Camera by DIPS
Refer to Setting Î System Î System page for detail DIPS information.
2.6 Configure IP Camera via Web UI
1. Start the web browser on the computer and type the IP address of the
Camera you want to monitor as below:
The Login Window of the Camera is prompted: