ADS-TEC OPC5117 - Manual (Page 21)

Industrial PCs OPC5117
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
21
8.6 N
ETWORK CONNECTION
(RJ45)
If the required drivers are installed on the device, the control system can be integrated in
an Ethernet network with 10/100 Mbit support using the Ethernet 10/100BaseT network
connector and a suitable network cable. The specifications of the underlying network
topology are to be adhered to. The drivers required to use this function can be installed
from the provided service CD if needed.
1 8
PIN NUMBER SIGNAL NAME
1
TX +
2
TX -
3
RX +
4
NC
5
NC
6
RX -
7
NC
8
NC
8.7 S
ERIAL
COM
INTERFACE
(RS232)
This interface should only be used for monitoring, debugging or a log printer because the
interface is not galvanically isolated.
PIN NUMBER SIGNAL NAME
1
DCD
2
RxD
3
TxD
4
DTR
5
GND
6
DSR
7
RTS
8
CTS
9
RI