Echo 73711S Instruction v.1 - Manual (Page 2)

INSTRUCTION SHEET
3. Begin placing the cutting blades (removed in step 5 of
the disassembly) into the blade openings of the aligned
space plates. (Placing two of the new 3/8" X 1 3/4"
carriage bolts (15059), up from the bottom, hrough the
hole locations will help keep the plates aligned during
the following steps.)
ASSEMBLING THE 12 BOLT/12 BLADE KIT, UPGRADE CUTTING SYSTEM
1. Begin by placing the painted bottom plate (76898-12
(with square holes)) on a flat working area.
2. Place the two spacer plates (76899-12) on the bottom
plate and align center spindle hole and 12 bolt holes
of the spacer plates to the spindle hole and bolt hole
of the bottom plate. (See photos below.)
Spacer plates INCORRECTLY
aligned to bottom plate.
Spacer plates CORRECTLY
aligned to bottom plate.
Angled Blade Inset
Straight Blade Inset
Angled Blade Inset
Straight Blade Inset