Echo 71755 Instruction - Manual

Instruction Sheet
Instructions
PN 76905-00
Rev. 092010
SUBJECT: 12-BLADE CUTTER
RETRO FIT KIT # 76903-00
FITS MODELS:
ALL STUMP GRINDERS
SERIAL # 0 - CURRENT
Before inspecting or servicing any part of this machine,
shut off power source and make sure all moving parts
have come to a complete stop.
WARNING
These instructions will describe how to install the 12-blade
retro fit cutter on stump grinders that currently have a
4-blade system.
12 BLADE CUTTER RETROFIT KIT, PN 76903-00
PART
NUMBER
DESCRIPTION OF PARTS
INCLUDED IN KIT
QTY
76904-00
ASSY., RETROFIT SG 12 BLD
CUT
1
1. Shut off engine and allow all moving parts to come to
a complete stop.
2. Take off the top cover of the stump grinder by removing
the seven bolts on the sides.
Loosen these bolts
3. Loosen the four engine mounting bolts. Two bolts are
located on top of the engine mount plate (see below).
Two are located on the other side of the engine under
the engine mount plate.
Loosen this nut
4. Loosen the nut on the back of the machine (see
below) and push the engine slightly forward to take
tension off the drive belt and spring.