Echo LS21 Instruction v.11 - Manual (Page 2)

Instruction Sheet
Figure 6
Figure 7
Figure 8
Figure 9
4. The tail light connector labeled with a tag that has
the word "GREEN" on it needs to be routed to the (as
you look at the machine from the rear) right tail light
assembly, The tail light connector labeled with a tag
that has the word "YELLOW" on it needs to be routed
to the left tail light assembly.
5. With the harness ends now in position, place the oval
shaped rubber tail light grommets in to place on the
light brackets.
Figure 11, green and white wires route to right side amber light
and yellow and white wires route to left side amber light
Figure 10
7. Now press the light into the rubber grommet and press
the light and grommet assembly into the oval hole in
the bracket.
8. Repeat steps 6 & 7 for the round marker light
9. Next, plug green and white harness wires into back of
amber marker light as shown in Figure 11 and attach
light to bracket.
6. Route the harness connector ends through the
grommet and connect it to the tail light by plugging the
three-pronged connector into the back of the light.