Echo LS21 Instruction v.11 - Manual (Page 3)

Instruction Sheet
Figure 12
Figure 15
Figure 13
Figure 16
Figure 14
HOOKUP AND TEST
1. Hook up the trailer light harness to the towing
vehicle.
2. Check to make sure that tail lights on the log splitter
work properly.
3. Towing laws may vary in different states. It is
recommended that you contact the local motor vehicle
department for any special regulations that pertain
to towing and know the laws of any state you travel
through.
10. Now, locate the license place mounting bracket. Route
the remaining harness connector end through the hole
in the bracket and attach it to the license plate light.
The wires of the harness, once they're connected,
should be orientated to go downward from the back
of the light.
11. Now connect the license plate light to the bracket
using two #10-24 x 3/4" screws and nylock nuts.
12. Mount the completed light and bracket assembly to
the machine at the location detailed in Figure 14 using
four 5/16 x 1" carriage bolts and nylock flange nuts.
13. To complete the routing of the wire harness to the front
of the machine, it will be necessary to mount three
additional coated clamps along the hitch pole.
14. Before mounting, locate the remaining three coated
clamps in the kit and route the harness through the
clamps.
15. First, you will need to remove the existing 3/8 x 3" bolt
at the hitch pole pivot location shown in Figure 15. To
do this, it is necessary to put the hydraulic cylinder
in the vertical position. This will take weight off of the
hitch pole and allow removal of the bolt. It is replaced
with a 3/8 x 3-1/4" bolt and added coated clamp
with harness routed through it. Secure in its original
position with new 3/8" flange nylock nut from kit.
16. Place two 5/16 x 3" bolts and washers through the
holes of the manual container and secure to the
hitch pole by adding last two coated clamps (with the
harness routed through them), 5/16 nylock flange
nuts. See Figure 16 for completed example.