Echo LS21160 Instruction v.8 - Manual (Page 3)

Instruction Sheet
24"
17"
RIGHT
LEFT
H
I
T
C
H
24"
48"
10"
40"
17"
LICENSE
LIGHT WIRE
(BLACK)
RH TAIL LIGHT
(GREEN/BROWN)
LH TAIL LIGHT
(YELLOW/BROWN)
15"
19. Run the YELLOW/BROWN wire to the left tail light the
same way as the GREEN/BROWN wire went to the
right tail light.
20. Strip the ends of all wires.
21. Wire the harness wires to the tail lights as follows:
• Yellow to LH tail light (STOP & TURN)
• Yellow/brown to LH tail light (TAIL)
• Green to RH tail light (STOP & TURN)
• Green/brown to RH tail light (TAIL)
22. Plug the yellow wire from the license light into the
other hole on the RH tail light (TAIL)
23. Secure the two tail lights to the tail light angles with
two 1/4" nuts and washers each.
24. Secure all conduit linkages with electrical tape.
hOOKUp AND TEST
1. Hook up the trailer light harness to the towing
vehicle.
2. Check to make sure that tail lights on the log splitter
work properly.
3. Towing laws may vary in different states. It is recommended
that you contact the local motor vehicle department for
any special regulations that pertain to towing and know
the laws of any state you travel through.
Fig. 9 Diagram of wiring the log splitter tail lights and license plate light
Fig. 10 Diagram of conduit lengths that need to be cut